Table of Contents
Advertisement
Installation and Setup Guide
To the Installer
MPICLTEU (US), MPICLTEC (Canada)
For mobile and fixed operating configurations, the antenna gain, including
cable loss, must not exceed 2.15 dBi at 700 MHz/850 MHz/1700 MHz/1900
MHz as defined in 2.1091 for satisfying RF exposure compliance. Under no
condition may an antenna gain be used that would exceed the 7W erp Part 22,
the erp 3W Part 27, the 2W eirp Part 24 and the 1W eirp Part 27 power limits.
4.5
Swapping the SIM Card
If you need to change the SIM card in the LTE module, you must restart the
control panel. If not, the new SIM card will not work.
To swap the SIM card in the LTE module, proceed as follows:
1.
Swap the SIM card.
2.
Restart the panel using the SHUTDOWN button. For details, see Shutting
Down the Panel Securely on page 122.
3.
Check the LTE module settings in MAXPRO Cloud, and test the
communication.
Caution!
If you change the Access Point Name (APN) for the LTE module in
MAXPRO Cloud (for example when changing providers), you have to
restart the control panel for the changes to take effect.
4.6
LED Indicators
LED
Power (green)
Network Connected
(yellow)
56
Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
Function
Device is powered.
Network connection status:
Short flash every 4 seconds: idle, normal state.
l
Short flash every 2 seconds: data transfer in
l
progress.
Fast flash (0.5s on, 0.5s off): no network or
l
connection issue.
800-23044 Rev. A draft_11
Hide quick links:
Advertisement
Table of Contents
