Installation; Installation And Setup - General Workflows; Initial Installation And Setup - Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
3

Installation

This chapter describes how to mount and wire the MPI Control Panel.
3.1 Installation and Setup – General Workflows
Installing a brand-new system or changing an existing system requires slightly
different steps. Both procedures are explained in the sections below.
3.1.1

Initial Installation and Setup

The recommended workflow for the initial installation and setup of an MPI
system requires the following steps:
Step
1. Mounting the cabinet that houses
the control panel.
2. Installing the control panel in the
cabinet.
3. Wiring the control panel: tamper
switches, network communication
(wired and cellular), inputs (zones)
and outputs (triggers), and alarm
sounders.
4. Installing an MPI Keypad on the
IB2 bus. Each control panel
requires at least one keypad.
5. Wiring additional devices on the
IB2 bus and/or the V-Plex loops.
800-23044 Rev. A draft_11
Installation and Setup Guide
For details, see...
Mounting the Cabinet on page 29.
Installing the Control Panel on
page 32.
Overview of Control Panel
Connectors on page 33 and
following, until Wiring Outputs on
page 48.
MPI Keypads MPIKTSMF,
MPIKTSPRX on page 59.
Installing IB2 Bus Devices on
page 58.
Installing V-Plex Devices on
page 101.
21