Disconnecting/Reconnecting; Receive Diversity Antenna System - Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
For more information on communication settings and transmission paths, and
setup for usage with AlarmNet, see the MAXPRO Cloud Configuration Guide
(doc. no. 800-24096).
4.3

Disconnecting/Reconnecting


Caution!
Removing power from the LTE module without properly shutting
down the control panel can result in permanent and irreparable
damage to the module. Always follow the procedure below if you
need to disconnect/reconnect the module.
To disconnect the LTE module, proceed as follows:
1. On the control panel, press the SHUTDOWN button for 5 seconds.
2. Wait for the control panel to shut down completely (= the SHUTDOWN
LED on the panel is off).
3. You can now disconnect the LTE module and remove any cables.
To reconnect the LTE module, proceed as follows:
1. Reconnect all cables carefully.
2. On the control panel, press the SHUTDOWN button once. The control
panel will power up.
4.4

Receive Diversity Antenna System

The primary antenna is used for transmit and receive. The secondary antenna
is the diversity antenna (receive only). The radio automatically determines and
selects the receive path that provides the best Quality of Service (QoS).
Install the antennas depending on the reception requirements, using any of
the options below. Always use both antennas.
Standard installation: Use both the primary and secondary antennas,
l
mounted on top of the MPI cabinet. Install the primary antenna on the
right-hand side, and the secondary antenna on the left-hand side.
Option 1: Use both primary and secondary antennas, mounted either
l
remotely or on top of the MPI cabinet in any combination. If mounting
remotely, use approved coax cables to connect the antennas to the LTE
module. For details on cabling, see Cable Type Requirements on page 171.
800-23044 Rev. A draft_11
Installation and Setup Guide
55