Table of Contents
Advertisement
GSMBR / iGSMBR Installation and Setup Guide
PROMPTS
Keypad Address
17
(28)_
Supervision
18
(24 Hours)_
Prompts 19 and 20 appear for the iGSMBR only.
GSM Rollover Y/N
19
(Y)_
GSM 24Hr Tst Y/N
20
(N)_
Old Alarm Time
21
10 Minutes_
3-14
Programming for Zone Trigger, 4204 and Two-4204 Modes
4204/
ZONE
ENTRY
2-4204
TRIG.
OPTIONS
[01-30]
This address must be programmed if using either
the Remote Access feature or Direct Wire
downloading. Enter the appropriate device
address.
NOTES:
1. This address must also be programmed as an
alpha keypad in the control panel or an AUI
(Advanced User Interface) type device, if a full
enhanced graphic interface to the system is
desired and the control panel supports it. DO
NOT connect an actual keypad (or any other
device) assigned to this address.
2. If using a compatible LYNXR-I series control
(when available), this address must be set to
"1."
3. This address must be unique from the "Device
Address" entered in Prompt 14, and cannot
equal that device address plus 1 (one) if using
2-4204 mode.
• 30 Day
The AlarmNet network must hear at least one
• 24 Hrs
supervisory message from the module during
this supervision period; otherwise, AlarmNet
• None
notifies the central station that a communication
failure has occurred. (If the supervision period is
changed after registration, you must re-register
the module.)
Press the [Space] key to scroll through choices.
[Y], [N]
If enabled, all messages (including AlarmNet
network supervisory messages) are sent over the
GSM network in the event of an Internet failure.
If disabled, all messages (except AlarmNet
network supervisory messages) are sent
automatically over the GSM network in the
event of an Internet failure.
[Y], [N]
If enabled, the
a message once a day to verify module operation.
A "secondary communication path loss" message
is generated if the message is not successfully
delivered.
• 10 Min
Sets how long an undeliverable alarm is retried
for delivery to the central station. If the message
• 4 Hours
is not validated, it is retried until the old alarm
• 15 Min
• 30 Min
time is reached or the message is validated.
Press the [Space] key to scroll through choices.
• 1 Hr
• 2 Hrs
• 4 Hrs
• 8 Hrs
• 12 Hrs
• 24 Hrs
DESCRIPTION
communications module
sends
Advertisement
Table of Contents
