Grizzly ARM 4041 Lion Set Translation Of The Original Instructions For Use page 35

with the directions in these
instructions. Ensure sufficient
distance between feet and the
rotating blades.
• Do not tilt the equipment when
starting other than if it is ne-
cessary to do so when starting
up in long grass. In this case,
tilt the equipment by pressing
down the handle bar such that
the front wheels of the equip-
ment are raised. Always check
that both hands are in the wor-
king position before returning
the equipment to the ground.
• Do not work without the grass
bag or collision guard. Keep
away from the ejection hole at
all times.
• Do not start the motor while
standing in front of the dischar-
ge duct.
Caution! Danger! The blade
continues to run after swit-
ching off.
There is a risk of injury.
• The equipment is not to be
lifted or transported while the
motor is running. Switch off
the equipment if it has to be
tilted in transit, when crossing
surfaces other than grass, and
when the equipment is being
transported to and from the
surfaces to be mowed.
• Always keep the grass ejection
hole clean and clear. Remo-
ve cut material only when the
equipment is stopped.
• Do not leave the equipment
unattended in the workplace.
• Do not work with equipment
that is damaged, incomplete,
or has been modified without
the authorisation of the ma-
nufacturer. Do not use the
equipment with damaged sa-
fety devices or screens or with
missing safety equipment such
as deflection and/or grass coll-
ection devices.
• Do not overload the equip-
ment. Work only within the spe-
cified power range and do not
change the regulator settings
on the motor. Do not use low-
powered machines for heavy
work. Do not use your equip-
ment for purposes other than
those for which it is designed.
• Do not use the equipment near
inflammable liquids or gases.
Non-observance will result in a
risk of fire or explosion.
• Switch the device off, pull out
the safety key and remove the
battery. Check that all moving
parts are at rest:
- Whenever you leave the ma-
chine,
- Before cleaning the ejection
hole or removing blockages,
- When the equipment is out of
use,
- Before checking, cleaning or
working on the equipment,
- If the equipment has hit a for-
eign object or if strange vibra-
tions occur during work. In this
case, check the equipment for
damage and have it repaired if
applicable.
- Ensure that all nuts, bolts and
screws are tightened firmly and
the equipment is in safe wor-
king condition.
• Check the mower for any da-
mages.
GB
35