Honeywell VARIODYN D1 Installation Instruction page 82

Installation Instruction VARIODYN
1
1
Fig. 76: Rear view
 + 
Connecting terminals (+ / -) for up to two 24 V batteries (
additional ports for charging the battery (M)

Connecting terminals for up to twelve power amplifiers (24 V / 40 A)

Connecting terminals for four control units, up to three DOM4-8 or 4-24 (24 V / 5 A) per connection

Fuse 6.3 AF

Ethernet port (Part No. 581725 only)

Female appliance connector for 230 V AC nominal voltage

Two inputs for external error messages (

Three output contacts (

Connecting terminals for temperature sensor

Output contact connectors or terminals
3-pin sockets are provided for the output contacts. 3-pin plugs are included with the delivery. If these are
plugged into the socket accordingly, they can be used as normally open or normally closed contacts of the
internal signal relays. Use YnTKSY 1 x 2 x 0.8 cable (Ø 0.8 mm
Mains Batterie Output
fault fault
Output contacts
82
®
D1 System
2
2
Mains fault / NETZFEHL
GND 13 14 15 16 17 18 19 20 21 22 23 24
fault
GND 1 2 3 4 5 6 7 8 9 10 11 12
3 4
10
3 4 5
BAT1, BAT2, BAT3, BAT4)
EXT FLT1 / EXT FEHL 1 and EXT FLT2 / EXT FEHL 2
,
BAT fault / BATTFEHL and Gen fault / SUMMFEHL
2
) for the connections.
UIM
GND 37 38 39 40 41 42 43 44 45 46 47 48
GND 25 26 27 28 29 30 31 32
5
6
9 8 7
and four
33 34 35 36
FB 798663.GB0 / 05.19
)
)