Honeywell VARIODYN D1 Installation Instruction page 80

Installation Instruction VARIODYN
1
Fig. 74: Rear view
 + 
Connecting terminals (+ / -) for up to two 24 V batteries (
charging the battery (M)

Connecting terminals for up to six power amplifiers (24 V / 40 A)

Connecting terminals for two control units, up to three DOM4-8 or 4-24 (24 V / 5 A) per connection

Fuse 6.3 AF

Connecting terminals for temperature sensor

Ethernet port (Part No. 581724 only)

Female appliance connector for 230 V AC nominal voltage

Two inputs for external error messages (

Three output contacts (

Output contact connectors or terminals
3-pin sockets are provided for the output contacts. 3-pin plugs are included with the delivery. If these are
plugged into the socket accordingly, they can be used as normally open or normally closed contacts of the
internal signal relays. Use YnTKSY 1 x 2 x 0.8 cable (Ø 0.8 mm
Mains Batterie Output
fault fault
Output contacts
80
®
D1 System
2
Mains fault / NETZFEHL
GND 13 14 15 16 17 18 19 20 21 22 23 24
fault
GND 1 2 3 4 5 6 7 8 9 10 11 12
3 4 5 6
BAT1, BAT2)
EXT FLT1 / EXT FEHL 1 and EXT FLT2 / EXT FEHL 2
,
BAT fault / BATTFEHL and Gen fault / SUMMFEHL
2 ) for the connections.
UIM
GND 37 38 39 40 41 42 43 44 45 46 47 48
GND 25 26 27 28 29 30 31 32
7 8
10
9
and two additional ports for
34 35 36
33
FB 798663.GB0 / 05.19
)
)