Firmware Update - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

Firmware Update

On the System / Firmware Update page, you can update the firmware of the access point and
configure the automatic check for updates of the access point's firmware.
The current version of the access point's firmware is displayed in the Current firmware version
field.
By default, the automatic check for the access point's firmware updates is enabled. If the Access
point or Repeater mode was selected in the Initial Configuration Wizard and the Static value is
selected from the Mode of local IP address assignment list on the Connections Setup /
LAN page, the Gateway IP address field should also be filled in on order to realize automatic
check.
If a firmware update is available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the left and click the APPLY SETTINGS button.
To enable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the right. In the Interval field, specify the time
period (in seconds) between checks or leave the value specified by default (43200).
By default, in the Remote server URL field, the D-Link update server address
(fwupdate.dlink.ru) is specified. To add one more address, click the ADD button and enter
the address in the displayed line. To remove the address, click the Delete icon (
the address.
Click the APPLY SETTINGS button.
You can update the firmware of the access point locally (from the hard drive of your PC) or
remotely (from the update server).
Figure 149. The System / Firmware Update page.
Page 204 of 235
Configuring via Web-based Interface
) in the line of