D-Link DAP-600P User Manual page 145

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
To activate the Super Mesh function, on the tab of the relevant band, move the Enable Super
Mesh switch to the right. You can specify the following parameters:
Parameter
Domain
IPv6
Enable gateway
Figure 114. The Wi-Fi / Super Mesh page.
An identifier which shows that the device belongs to a certain Mesh
network. This value should be the same for all devices of your Mesh
network.
If you need to use IPv6 for configuring the Mesh network, move the
IPv6 switch to the right.
Move the switch to the right to allow devices of the Mesh network to
use this device for connecting to the Internet.
It is recommended to move the switch to the right when configuring
the main device.
It is recommended to move the switch to the left when configuring a
subordinate device.
Page 145 of 235
Configuring via Web-based Interface
Description