Next task
User manual for HON R100 gas pressure regulator with HON P095NG pilot
If ...
The magnetic ring is resting over the position
indicator's housing in the position shown in step 4
The magnetic ring is NOT resting over the position
indicator's housing in the position shown in step
4, but is instead in a higher or lower position
Figure
Depending on what you will be doing next, proceed as indicated in the relevant section:
Completing the maintenance (see page 76)
Maintaining the pilot (see page 62)
Storing the device (see page 78)
then ...
proceed with step 6.
proceed with step 5.
Step
Description
5
Remove the magnetic ring from the
position indicator's housing, turn it 180°,
and place it back over the housing.
6
Place the sight glass (2) and the cover ring
(1) back on the position indicator's hous‐
ing. Make sure that the magnetic ring stays
in the required position.
7
Install the retaining ring (1).
Maintenance
61