Table of Contents
Advertisement
6
1.
Safety instructions
Danger for device or user if ignoring the following safety instructions!
*
Please read this manual carefully and completely before installing and starting to work with the ACS-2
plus.
*
Only use the ACS-2 plus:
- according to the designated use and
- in technically perfect condition
- in correctly installed condition
- according to the technical data.
*
The manufacturer cannot be held liable for damage resulting from use contrary to the designated
purpose.
*
Store the documents accompanying the product and the product-specific notes in a safe place.
*
Mounting, programming, maintenance and repair work must be carried out only by authorized and trained
persons.
*
Soldering and connecting work on the entire system may only be carried out when disconnected from
the power supply.
*
Soldering work must only be performed with a temperature-regulated soldering iron, galvanically
separated from the power supply.
*
The VDE safety regulations and the prescriptions of the local electricity supplier have to be observed.
*
Danger:
1.1
Installation and subsequent extensions
Attention: Switch off the supply voltage before opening the device.
The VDE regulations and the regulations of the electricity supplier must be observed during installation. Carry
out the connections between the control unit and the external devices according to the connection diagrams.
A separator (circuit breaker) must be integrated in the installation of the building.
Use only shielded lines (see chapter 5 = Important installation instructions).
When using a DC door strike, special attention is to be paid to correct polarity. Use only DC door strikes equipped
with a protective diode.
The ACS-2 plus must not be used in an explosion endangered environment or in rooms
with metal- or plastic-decomposing vapors.
Installation instructions / ACS-2 plus
Advertisement
Table of Contents
