Table of Contents
Advertisement
Installation instructions / ACS-2 plus
10. Commissioning
During commissioning of the ACS-2 plus, the following steps must be carried out:
1.
Insertion of the back-up battery (see chapter 8.4).
2.
Connection to the mains.
3.
Bootstrap via the DIP switch S1 (see chapter 8.5.1, table 4).
The ACS-2 plus is brought to the defined initial state.
4.
Checking/setting the necessary parameters via DIP switches or the ACS-2 plus setup.
5.
Setting the controllers in NetEdit / IQ NetEdit (see chapter 10.2 and NetEdit / IQ MultiAccess
installation instructions).
6.
Bootstrap of the controller via the MultiAccess for Windows software (see user manual of
MultiAccess for Windows part B, chapters 5 and 6) and/or IQ NetEdit / IQ MultiAccess.
Please refer to the table in the appendix containing the factory settings which are valid after bootstrap
and setting the controller as long as the factory settings have been applied or have not been changed.
10.1 ACS-2 plus setup
The ACS-2 plus is delivered in a predefined initial state (see factory settings in the following or in the
appendix).
This initial state must be checked and changed if necessary. There are two possibilities:
Variant 1:
Basic setting via the DIP switch S1 (see chapter 8.5.1)
Procedure:
There are only limited possibilities in making settings via the DIP switches (as described in
the tables in chapter 8.5).
The variant 2 of the ACS-2 plus setup offers considerably more comfortable and extensive
possibilities.
Variant 2:
Basic setting via ACS-2 plus setup
General description:
1. Setting the protocol
2. Setting the baud rate
3. Setting the address
The ACS-2 plus setup makes it possible to check and to modify, if
necessary, the current settings of the ACS-2 plus. This is also
possible during normal operation without impeding operations.
The number of parameters to be modified depends on the DIP
switch setting of the S1 switch block.
43
Advertisement
Table of Contents
