Table of Contents
Advertisement
SECTION 7: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Schedule
For optimum performance from this machine, this
maintenance schedule must be strictly followed.
Ongoing
To maintain a low risk of injury and proper
machine operation, if you ever observe any of the
items below, shut down the machine immediately
and fix the problem before continuing operations:
•
Loose mounting bolts/arbor bolt.
•
Damaged saw blade.
•
Worn or damaged wires.
•
Any other unsafe condition.
Weekly Maintenance
•
Clean table surface.
•
Wipe dust/debris off slide bars.
•
Clean fence and fence extension trackways.
•
Remove table inserts to clean/vacuum dust
buildup from inside table insert channel.
Re-install before operating.
Monthly Check
•
Vacuum or blow out motor air vents.
Model T31634/T31635 (Mfd. Since 8/19)
Cleaning &
Protecting
Cleaning the Model T31634/T31635 is relatively
easy. Vacuum excess wood chips and sawdust,
and wipe off the remaining dust with a dry cloth.
If any resin has built up, use a resin-dissolving
cleaner to remove it.
Lubrication
The bearings on your miter saw are shielded and
permanently lubricated, so they require no further
lubrication.
The sliding parts on the saw function best through
dry operation as grease and other lubricants
attract dust and grit that gum up their movement.
The lubrication applied at the factory should suf-
fice for the life of your saw.
However, in the event that the movable parts do
become difficult to operate, a light machine oil
may be used on the following parts after thor-
oughly cleaning the components:
•
Slide bars
•
Table extension rods
•
Miter table path
•
Bevel axis screw
•
Fence extension rails
-39-
Advertisement
Table of Contents
