Locking Cutting Head; Using Hold-Down Clamp - Grizzly T31634 Owner's Manual

Locking
Cutting Head
Your miter saw is equipped with an operating
handle for cutting head control, and two additional
handles to easily transport your saw.
For maximum safety during transport or storage,
lock the cutting head down by following the steps
below.
Note: Head release knob is only to be used to
lock cutting head for carrying and storage, not for
cutting procedures.
To lock cutting head:
1. DISCONNECT MACHINE FROM POWER!
2. Lower cutting head until blade reaches past
table inserts. While holding in this position,
push head release knob to lock (see Figure
40).
Head Release
Knob
Figure 40. Locking cutting head down.
-28-
Using
Hold-Down Clamp
Your miter saw is equipped with a hold-down
clamp for use with the table on either side of the
blade.
To use hold-down clamp:
1. Insert clamp base into desired mounting hole
on either side of blade (see Figure 41).
Figure 41. Hold-down clamp mount.
2. Tighten clamp knob (see Figure 42) until it
secures workpiece to table.
Figure 42. Hold-down clamp knob.
Model T31634/T31635 (Mfd. Since 8/19)