Using Table Extensions; Using Fence Extensions - Grizzly T31634 Owner's Manual

Using
Table Extensions
The table extensions on either side of your saw
allows for extra support for larger workpieces.
To use table extensions:
1. Lift table extension lock (see Figure 43) then
pull to extend. Press lock to secure extension
in position.
2. Lift stop to secure workpiece so it is not dis-
lodged by pressure of blade (see Figure 43).
Table Extension
Lock
Figure 43. Table extension supporting long
workpiece.
Model T31634/T31635 (Mfd. Since 8/19)
Workpiece Stop
Using
Fence Extensions
The removable fence extensions can support not
only taller workpieces but also longer ones.
However, remember you should always place
the side or tallest part of the workpiece down flat
against the table for maximum support and not on
its end where it could flip during a cut (see Figure
44).
Figure 44. Correct placement of tall workpiece.
To use fence extensions:
1. Lift fence extension lock (see Figure 43),
then pull to extend. Press lock to secure
fence in position.
Note: Do not extend fence so far that set
screw (pictured in Figure 45) does not con-
tact fence extension.
Fence
Extension Lock
Figure 45. (1 of 2) fence extension set screws.
Set Screw
-29-