Workpiece
Finished
Piece
Figure 56. Inside corner, right side.
Workpiece
Figure 57. Outside corner, left side.
Workpiece
= Top
= Line of cut
Figure 58. Outside corner, right side.
Model T31634/T31635 (Mfd. Since 8/19)
Fence
= Top
= Line of cut
Fence
Finished
Piece
= Top
= Line of cut
Fence
Finished
Piece
Adjusting Depth
To perform "non-through" cuts, adjust the depth
of cut on the Model T31634/T31635 as described
below.
To adjust depth of cut:
1.
DISCONNECT MACHINE FROM POWER!
2.
Raise cutting head all the way up.
3.
Loosen depth stop plate screw (see Figure
59) and slide plate forward until stop screw
will not pass through plate hole when cutting
head is pulled down. Retighten screw.
4.
Pull cutting head down until blade teeth reach
desired depth of cut. Hold cutting head in this
position and turn stop screw until it contacts
plate (see Figure 59).
5.
Tighten knurled nut to secure setting (see
Figure 59).
Stop Screw
Depth Stop
Plate Screw
Figure 59. Depth adjustment hardware.
6.
Perform test run by pulling cutting head down
and through full motion of typical cut to con-
firm desired depth is set.
Knurled Nut
Depth Stop
Plate
-33-