Table of Contents
Advertisement
6.
While pressing arbor lock, use included
combo tool to loosen and remove arbor bolt,
flange, and blade. Arbor bolt has left-hand
threads; rotate clockwise to loosen.
Note: Model T31635 has a 5/8" reducer
bushing that must be removed as well.
7.
Install new blade and secure with flange and
arbor bolt on arbor, as shown in Figure 34.
Note that the reducer bushing for the T31635
must be installed before the flange and arbor
bolt.
Note: Ensure arrows on blade are oriented
in same direction as arrow on upper blade
guard.
T31634
T31635
Figure 34. Correct order of installation with teeth
facing the correct direction.
8.
Press and hold arbor lock and rotate blade
until lock engages.
9.
Tighten arbor bolt.
10. Replace cover plate and retighten cover plate
screw.
11. Position lower blade guard so it is covering
blade. Verify that it operates smoothly without
binding or sticking.
-26-
Chop Cut Steps
Performing Cuts
Steps
Performing Cuts
Models T31634 and T31635 are equipped with
trigger switches and release buttons to prevent
accidental start up.
They also are equipped with slide bars that allow
for up to 9
⁄
" of sliding travel. Therefore, the
3
8
user has the option of using simple chop cuts for
smaller workpieces, or push cuts for larger stock.
Note: When cutting workpiece longer than the
table, support workpiece so it lays flat on the table.
If you must cut a slightly warped workpiece, be
sure to secure the convex side to the fence.
Performing a Chop-Cut
1.
Measure workpiece and mark with cutting
line.
2.
Set desired miter (see Cutting Miters on
Page 30) or bevel angle (see Cutting Bevels
on Page 31).
3.
Slide cutting head to rear of unit and tighten
slide lock knob (see Figure 35).
Figure 35. Saw set for plunge cut.
4.
While keeping hands out of No Hand Zone,
hold workpiece firmly against table and fence.
Use hold-down clamp if possible.
5.
Perform a "dry run" by pulling cutting head
down to confirm where blade will contact
workpiece, allowing for kerf thickness of what
will actually be removed.
Model T31634/T31635 (Mfd. Since 8/19)
Slide Lock
Knob
Advertisement
Table of Contents
