Makita UH7580 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Lifter section
DISASSEMBLING
Refer to the clause of [3]-3.
ASSEMBLING
Set the components in place while pay attention to the linked portions illustrated in Fig. 18.
Three plates X, Y and Z of Lifter have to be linked with each appropriate portion in the following order.
1. Plate X is fit into the U groove of Pusher cap.
2. Plate Y is put on the hook portion of Lever.
3. Plate Z is fit into the groove of Switch lever A.
Fig. 18
Switch lever A
Switch lever C
X
Z
Z Y
X
Link
Rod
Gear housing
Insulation cap
Compression
spring 8
Pin 5 (to the hole of
Gear housing through
Cap holder, Lifter,
Pin holder,
Compression spring 5
Cap holder
and Stop ring E-4)
Lifter
Pin holder
Compression
spring 5
Stop ring E-4
Y
Lever
P 6/ 7
Pusher cap
Pin 3
(for pushing Link)