Exiting Menu Mode; Diagnostic Mode; Enter Diagnostic Mode; Navigating Diagnostic Mode - Honeywell BW RigRat User Manual

10.2.2. Exiting Menu Mode

There are two ways to exit Menu Mode:

If you do not press a button, after 20 seconds it will revert to the main screen.

Press the button until you reach "Exit."

Diagnostic Mode

In Diagnostic Mode, the RigRat provides information about the instrument, battery, pump, etc., as well
as a list of installed sensors and information about them (expiration date, serial number, etc.). Most of
these screens are useful only to service technicians.

Enter Diagnostic Mode

When the instrument is off, press and hold the button for more than 10 seconds after the 3-second
countdown. The instrument starts self-testing and then enters Diagnostic Mode. In Diagnostic Mode,
briefly press the button to navigate through the screens of instrument status, test LCD, LED, buzzer
and pump.

10.4.1. Navigating Diagnostic Mode

Step through Diagnostic Mode by pressing the button. The first screen shows information about the
product, including the serial number, firmware version, etc. Exit Diagnostic Mode at any time by
shutting the instrument off at this screen (hold the button for the 3-second countdown).

Instrument model name and ID number (in hexadecimal)

Serial number

Instrument firmware Version

Firmware build date

Firmware build time

RTC

Sensors Installed

Socket Raw Counts (for all enabled sensors)

Sensors Serial Number

Sensors Zero and Span raw counts

Sensors produced date and warranty

Battery capacity/voltage/current/temperature/SOH/cycle counts

Battery current at idle mode (Hold button to enter idle mode and calculate)

RAEMet readings (if installed)

Noise sensor information (if installed. Hold to start calibration.)

GPS information (if installed)

LCD test (Hold to start test procedure.)

LED and Buzzer test (Hold to start test procedure)

Switch output/Digital input/4~20mA information (Hold to test switch output.)
BW RigRat User's Guide
49