Camera - Honeywell CK75 Repair Manual

TITLE
CK75 Repair Manual
Installation
Installation is reverse order of removal.
1.
Position the WAN antenna onto the scan bracket assembly.
2.
Using a #1 Phillips screwdriver install 3 screws and secure the WAN antenna to the scan bracket assembly with
2.5+/-0.2 in-lbs of torque.
3.
Re-install the scan bracket assembly.
4.
Re-install the bottom housing assembly.
OPERATION:

Camera

The camera is located on the scan bracket assembly. To service the camera you will need to remove the scan bracket assembly.
Tools Required
Description
T10 Torx driver
T7 Torx driver
Phillips screwdriver with #1 tip
Parts Required
Item Part Number
1 850-583-001
2 8754-870903-03
3 8754-870903-04
4 8754-870901-01
5 8754-870900-11
6 8754-870900-06
7
8754-870903-02
48-454675-01
** units without a camera but with a WAN radio will have this blank metal piece installed in place of a camera. Units without a
camera and without a WAN radio will have nothing installed in the camera location.
Removal
1.
Remove the bottom housing assembly (refer to Bottom Housing operation).
2.
Remove the scan bracket assembly (refer to Scan Bracket Assembly operation).
3.
Using a #0 Phillips screwdriver remove four screws that secure the camera to the scan bracket assembly.
The camera shield and camera can now be removed. Compress the grounding gasket on the back of the flex cable to slide the
flex through the slot in the scan bracket assembly.
Model
CK75
Description
CAMERA MODULE ASSY, 5MPIXEL,AUTOFOCUS
SHIELD,CAMERA,SUS304,CK75
SPACER,CAMERA LED,PORON,CK75
TAPE,KAPTON,24.4MM*5MM,CNCK75
FLEX CABLE,CAMERA,CK75
HOLDER,CAMERA FLEX,SUS304,CNCK75
CONDUCTIVE FABRIC,CAMERA FLEX,CK75
Screw, ST1.4*0.45*2.3,PH,PAN,ST,NB
L3-GLBL-RPR-4516 (Rev A)
DOCUMENT NO.
L3-GLBL-RPR-4254
Page 34 of 42
(Rev A)
Part Number
PAGE
Qty
1
1
1
1
1
1
1
4