Core Assembly - Honeywell CK75 Repair Manual

TITLE
CK75 Repair Manual
Parts Required
Item Part Number
1 8754-870903-06
2 8754-870903-07
Supercap
assembly
Removal
1.
Remove the bottom housing assembly (refer to Bottom Housing operation).
2.
Note orientation of existing super cap.
3.
Remove two screws that secure the supercap bracket to the bottom housing.
4.
Remove the supercap assembly.
5.
Remove the supercap from the retaining bracket as needed.
Installation
1.
If you are installing a new supercap peel the adhesive release liner from the adhesive patch installed on the new supercap.
2.
Place the supercap in the bottom housing with the connecting cable oriented as shown above.
3.
Place the retaining bracket over the supercap assembly carefully aligning it with the supercap and the mounting holes
prior to contacting the adhesive patch.
4.
Install two screws with 1.2 +/- 0.2 in-lb of torque
5.
Re-install the bottom housing assembly.
OPERATION:

Core Assembly

The core assembly will need to be removed from the top housing in order to access and/or replace assemblies attached to
the magnesium frame or to replace the top housing assembly itself.
Tools Required
Description
T10 Torx driver
T7 Torx driver
Description
SUPERCAP W/WIRE,CK75
BRACKET,RETENTION,SUPERCAP,PB,CK75
Model DOCUMENT NO.
CK75
L3-GLBL-RPR-4254
2
Part Number
PAGE
Page 20 of 42
(Rev A)
Qty
1
1