Exchange Of Cover - Makita VC2012L Service Manual

1. EXCHANGE OF COVER

Insert the tip of flathead screwdriver into the
gap between Handle and Cover. Then,
remove the upper part of Handle.
SCREW 5X18
TX20
Remove two Screws of Handle part, and
then remove Handle and Motor head cover.
HANDLE BLACK
COVER
DEDUSTING ROD
When removing Filter cleaning, insert the tip of flathead
screwdriver into the gap, and pry it off slowly.
DEDUSTING KNOB
BLACK
Raise both (right & left) sides of Knob equally, in order to
prevent damage on the resin material of Knob. When
removing Knob, make sure not to let the Compression
spring fall down.
CLAMPING
PLATE
When assembling the Cover, make sure
not to forget to assemble Dedusting rod
in advance.
3