ENGLISH (Original instructions) SPECIFICATIONS Model VC1310L / VC2510L / VC3210L AU/NZ GB 110V GB 230V Voltage Volt 230 - 240 230 - 240 230 - 240 Power consumption Watt 1050 1050 1050 1050 1050 Connected load for Watt at 2400...
Page 3
A power source with voltage greater Vacuum Cleaner than that specified for the cleaner can result in Model No./ Type: VC1310L, VC2510L, VC3210L SERIOUS INJURY to the operator as well as are of series production and damage to the cleaner. If in doubt, DO NOT Conforms to the following European Directives: PLUG IN THE CLEANER.
21. Clean and service the cleaner immediately 34. Young children should be supervised to after each use to keep it in tiptop operating ensure that they do not play with the cleaner. condition. 35. Never handle plug cord or cleaner with wet 22.
symbol. electric power tool input power. Switching on and off of the connected electric power tool Connecting electric power tools simultaneously brings the cleaner switching on and off action. The cleaner still works for a few seconds even WARNING: after the electric power tool is switched off. Observe the maximum connected loads for the •...
Page 6
Locking or unlocking the caster Storing the power supply cord NOTE: Do not use the cleaner or a connected electric For Models VC1310L and VC2510L • power tool with a power supply cord wound on the base hook. Using the cleaner or the connected 1.
Page 7
between the water filter and the tank. Installing the water filter Also, install the water filter so that the mounting position marking can be aligned. NOTE: Models VC2510L and VC3210L have no mounting • position marking and no need to align it. Installing the paper pack WARNING: When using the paper pack, also use the prefilter...
Page 8
1. Tank cover Installing the pipe holder (optional accessory) 2. Protrusion of the For Model VC1310L only pipe holder 3. Groove 1. Cord hook 011607 011604 Depress the cord hook as shown in the figure. 011608 Fit two protrusion of the pipe holder into the grooves of the tank cover and then press down the pipe holder.
Page 9
pulling the hose may cause a breakage or Too much dust will tear the bag easily, so do not • deformation of the hose. collect the dust more than the half of the bag When picking up large wastes such as planer capacity.
Storage of power supply cord 1. Tank cover 2. Powder filter 3. Damper For Model VC1310L only 4. Prefilter 5. Tank 1. Cord hook 6. Mounting position marking 2. Power supply 011637 cord Place the prefilter in the tank.
Applying an excessive force to these accessories may cause damage to the pipe holder. For Model VC1310L only 011622 Pipe rest can be used to store straight pipe, bent pipe and others by just inserting these accessories.
Page 12
Cleaning If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. CAUTION: Hose (1.5 m, 2.5 m, 3.5 m or 5 m) •...
Page 16
Makita Corporation Anjo, Aichi, Japan www.makita.com 884995-229...