Honeywell AlarmNet IGSMHS Installation And Setup Manual page 24

IGSMHS Installation and Setup Guide
PROMPTS
21 Supervision
(UL Hi Line Sec)_
NOTE: The next prompt only appears if the Comm Path Choice is IP&GSM.
22 GSM 24Hr Tst Y/N
(N)_
Old Alarm Time
23
10 Minutes_
NOTE: The next prompt only appears if the Comm Path Choice is IP&GSM, or IP.
24 IP Flt Time
(01 mins)_
NOTE: The next prompt only appears if the Comm Path Choice is IP&GSM, or GSM.
GSM Flt Time
25
(01 mins)_
NOTE: The next prompt only appears if the Comm Path Choice is IP&GSM.
Notify Panel Of_
26
(Both IP&GSM Flts)
3-6
ENTRY OPTIONS
 UL Hi Line
Sec
 3 Minutes
 6 Minutes
[Y], [N]
10 Minutes
 15 Minutes
 30 Minutes
 1 Hour
 2 Hours
 4 Hours
 8 Hours
 12 Hours
 24 Hours
[00-99]
[00-99]
[Both IP and
GSM Faults]
[Neither fault]
DESCRIPTION
The AlarmNet network must hear at least one
supervisory message from the module during this
supervision period; otherwise, AlarmNet notifies the
central station that a communication failure has
occurred. (If the supervision period is changed after
registration, you must re-register the module.)
Press the [space] key to scroll through choices.
NOTE: When "UL Hi Line Sec" is selected, a loss of
communications is treated as an alarm condition.
UL: Must be set to "UL Hi Line Sec" (200 sec).
If enabled a message is sent every 24 hrs over GSM to
verify proper operation. If it fails, a Periodic Comm
Test Failure message will be sent over Ethernet.
UL: Must be set to "Y".
Sets how long an undeliverable alarm is retried for
delivery to the central station. If the message is not
validated, it is retried until the old alarm time is
reached or the message is validated.
Press the [space] key to scroll through choices.
UL: Must be 10 minutes.
In the event there is a loss of contact with the network
over the Ethernet connection, enter the time delay (in
minutes) before the IGSMHS notifies the central
station. IP failure will always be sent to the central
station as Primary Communication Path Failure.
UL: Must be one (01) minute.
In the event the module detects a communication path
failure, enter the time delay (in minutes) before the
IGSMHS notifies the central station. A GSM failure
will always be sent to the central station as Secondary
Communication Path Failure.
UL: Must be one (01) minute.
If "Both IP and GSM Faults" is selected, the device
will only notify the control panel if both
communication paths fail, but will always send
notification of either failure to the central station.
NOTE: The fault relay output (if programmed) will be
triggered only if "Both IP and GSM Faults" is selected.
Press the [space] key to scroll through choices.
UL: Must be set to "Both IP and GSM Faults".