Honeywell AlarmNet IGSMHS Installation And Setup Manual page 23

Internet communication module
Table of Contents

Advertisement

PROMPTS
Primary City ID
11
(??)_
12
Primary CS ID
(??)
Primary Sub ID
13
(????)
14
En. 2nd CS Y/N
(N)_
2nd City ID
15
(??)_
2nd CS ID
16
(??)_
17
2nd Sub ID
(????)_
Device Address
18
(03)_
19
Direct Wire Y/N
(N)_
20
Keypad Address
(28)_
ENTRY
OPTIONS
[01-99]
[01-FE]
[0001-9999]
[Y], [N]
[01-99]
[01-FE]
[0001-9999]
[01-30]
[Y], [N]
[01-30]
Section 3: Programming the IGSMHS
DESCRIPTION
Enter the 2-digit primary city ID, 01-99 (decimal).
Enter the 2-digit primary central station ID number,
01-FE (HEX).
Enter the 4-digit subscriber account number, 0001-
9999 (decimal).
Applicable only if control panel supports Central
Station #1 and #2 Category Enable reporting for the
communications device (LRR) (e.g., VISTA-128BP,
FA1660C, etc.).
Used if reporting to a second central station is desired.
If [N], go to Prompt 18: "Device Address."
Enter the 2-digit secondary city ID, 01-99 (decimal).
Enter the 2-digit second central station's ID number,
01-FE (HEX).
Enter the 4-digit subscriber account number for the
second central station, 0001-9999.
In ECP mode, the IGSMHS communicates with the
control panel as a communications device (LRR).
Enter the appropriate ECP device address. For
VISTA-10 and VISTA-20 series control panels, use
address 03. For other controls, see the control panel's
Installation and Setup Guide.
NOTES:
1. When programming the control panel, enable the
LRR output.
2. The device address must be unique from the
"Keypad Address" entered in Prompt 20.
Downloading
Enables Direct Wire
applies only to the Vista-32FB and VISTA BP and
FBP series control panels with revision 3.x. BP and
FBP panels rev 4.x and higher support Downloading
via IP over ECP. If [N], skip to Prompt 21:
"Supervision."
Must be programmed if using Direct Wire
downloading.
NOTES:
1. This address must also be programmed as an alpha
keypad in the control panel or an AUI (advanced
user interface) type device, if a full enhanced
graphic interface to the system is desired and the
control panel supports it. DO NOT connect an
actual keypad (or any other device) assigned to this
address.
2. This address must be unique from the "Device
Address" entered in Prompt 18.
over IP. This
3-5

Advertisement

Table of Contents
loading

Table of Contents