Honeywell AlarmNet IGSMHS Installation And Setup Manual page 22

IGSMHS Installation and Setup Guide
PROMPTS
3 Program Device?
(Y/N)_
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)_
Enter Password
6
Verify Password
7
Exit Prog. Mode?
8
(Y/N)_
Comm Path
9
Choice
(IP&GSM)_
10 Device Mode
(ECP)_
Important Information Regarding Primary and Secondary Accounts (Prompts 11-17)
Account information is provided by the central station administrator. If the control panel
supports secondary account reporting, you will need secondary account information. The City ID,
CS ID or Subscriber ID of the secondary account must differ from that of the primary account.
3-4
ENTRY OPTIONS
[Y], [N ]
[Y], [N]
[Y], [N]
[0-9, A-F, N, S,
T, X, Y]
[0-9, A-F, N, S,
T, X, Y]
[Y], [N]
[ESC]
 IP&GSM
 IP
 GSM
 ECP
 Zone Triggers
 4204 Emu
 Two 4204s
DESCRIPTION
To begin programming the module, press [Y] and go to
Prompt 10: "Device Mode."
To create a password if none has been assigned, press
[N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program Device?"
prompt.
If a password is desired, press [Y] and go to "Enter
Password."
If a password has already been assigned, this prompt
appears after pressing [N] at the "Program Device?"
prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key when
prompted for the new password and its confirmation.
This prompt is displayed if [Y] was pressed in Prompt
4 or 5.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is displayed
directly.
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph in
this section.
Press the [space] key to scroll through the
communication path choices. Press [ENTER] to
select.
For maximum reliability, select IP&GSM, and ensure
the Internet is connected using the Ethernet cable.
NOTE: After going from a "GSM" only com path
choice to an "IP" only choice, Prompt 41: "DHCP" will
default to No.
Press the [space] key to scroll through the modes of
operation. Press [ENTER] to select ECP mode.
See Table 3-4 if programming other modes.