Event Logs - Cisco RP Series Installation Manual

Integrating UCS Components in the Dynamic Rack
The fields of interest in the output are shown here:
Chassis:
Chassis: 1
...
Vendor: Cisco Systems Inc Model: N20-C6508
Serial (SN): FOX1325G5G3
Fabric-A# recommission chassis "Cisco Systems Inc" "N20-C6508" "FOX1325G5G3" Fabric-A* #
commit
Repeat above steps for each connected chassis Fabric-A# show chassis
Chassis:
Chassis
---------- -------------- ----------
1
Step 2
Ensure that all chassis are present in the Operable state.
Step 3 Verify the Server Inventory by executing the following commands to see the servers on each chassis:
Example:
Fabric-A# ack chassis 1
Fabric-A# scope chassis 1
Fabric-A# show server inventory
The output is a sample for a UCS 5108 Blade Server chassis:
Server Equipped PID
Ackd Cores
-------
----------
1/1 N20-B6620-1 V01
1/2 N20-B6620-1 V01
1/3
1/4
1/5
1/6
1/7
1/8
Step 4 Verify that all chassis and servers are listed, and that the Memory and Cores match the BOM.
Step 5
Make sure that your Putty session is set to a minimum of 5000 lines to scroll back.
Step 6 At the console session, enter the following command to inventory the server-specific list:
server inventory expand
Step 7 Review the results to ensure that they include data for all server nodes.
Step 8
Repeat the preceding commands for Fabric Interconnect B to verify redundancy.

Event Logs

Make sure that there no Non-recoverable or Critical errors in the event logs. Enter the following command
to display the content of the log:
Overall Status Admin State
Operable Acknowledged
Equipped VID
------------ ------------ --------------------
QCI1404A3MG
QCI1405A1K0
Fabric-A# show fault
Cisco R42612 Rack and RP-Series Metered Input PDU Installation Guide
Equipped Serial (SN) Slot Status Ackd Memory (MB)
---------------- ----------------
Equipped 49152
Equipped 49152
Event Logs
8
8
Empty
Empty
Empty
Empty
Empty
Empty
Fabric-A# show
79