Reversing The Front Door - Cisco RP Series Installation Manual

Replacing Components
Procedure
Step 1
Unlock and open the door by pulling the handle bottom out and rotating the handle 90° clockwise.
Step 2 While holding the door steady, lift the captive hinge pins until they unlock. See the following figure.
Tip
Step 3
Hold the door with both hands and pull it away from the hinges; once removed, store the door in an upright
position against a flat surface.

Reversing the Front Door

To reverse the front door on the Cisco R42612 Rack so that it opens in the opposite direction, follow these
steps:
Procedure
Step 1 Remove the door as described in
Step 2
Use a 4 mm hex wrench to remove the top and bottom hinges from the rack. See the following figure, callout
1.
One person should be able to remove the front door unassisted, but having a second person present
to hold the door while the other slides the pins out can speed up the process.
Removing and Installing the Front Door, on page
Cisco R42612 Rack and RP-Series Metered Input PDU Installation Guide
Reversing the Front Door
44.
45