Cisco RP Series Installation Manual page 43

Installing Cisco RP-Series PDUs
Table 5: 1RU and 2RU PDU Specifications
Product ID
RP208-30M1P-4-8
RP208-60M3P-12
Warning No serviceable parts inside. To avoid risk of electric shock, do not open.
Warning Read the installation instructions before using, installing or connecting the system to the power source.
Warning This product relies on the building's installation for short-circuit (overcurrent) protection. To reduce risk of
electric shock or fire, ensure that the protective device is rated not greater than:
Warning This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Warning For Nordic countries (Norway, Finland, Sweden and Denmark) this system must be installed in a Restricted
Access Location, where the voltage of the main ground connection of all equipment is the same (equipotential
earth) and the system is connected to a grounded electrical outlet.
Warning
Connect the device to a grounded power outlet.
To install a 1RU or 2RU PDU, follow these steps:
Procedure
Step 1
Attach the four cage nuts to the interior side of the rack posts, spacing the nuts apart to the 1RU or 2RU
position, depending on which PDU you are installing.
Step 2 Use the supplied mounting screws to secure the unit in place, as shown in the following figures.
Description
30 A, metered input, single-phase,
horizontal-mount PDU with 4 C19
and 8 C13 connectors
60 A, metered input, three-phase,
horizontal mount PDU with 12 C 19
connectors
Cisco R42612 Rack and RP-Series Metered Input PDU Installation Guide
Installing a 1RU or 2RU PDU
Plug Country
L6-30P North America
IEC 60309 North America
460P9
41