Fastrak Optical Tracker - Honeywell VXP System Maintenance Manual

4.2.1.4 FasTrak Optical Tracker

The FasTrak Optical Tracker should be inspected per Table 4-5.
Inspection
Exterior
Interior
NOTE: The infrared light-emitting diodes (LEDs) are factory aligned and may appear to
be pointing randomly. This configuration is normal.
Table 4-5. FasTrak Optical Tracker
Procedures
Inspect the housing for loose
screws.
Inspect the filter window for
cracks or looseness.
Inspect the filter window for
clarity.
Inspect the cable connector
for bent or broken pins.
Inspect the Delrin mounting
base for general condition and
security. Closely inspect the
four mounting holes for
deformations, cracks, or
excessive wear.
Shake the unit and listen for
any loose internal
components.
Looking through the filter
window, check the lens for
cleanliness, cracks, and
general alignment.
The lens tube must be clear of
polished or reflective
surfaces, where the flat black
paint finish may have worn or
flaked away.
Remedy
Remove any loose screws and
apply Loctite before
reinstalling them.
Return to Chadwick-Helmuth
for repair.
Clean the filter window with
any standard glass cleaner
and a soft, clean lint-free
cloth.
Replace the cable connector
(see Section 5.2, Cable
Repair).
Return to Chadwick-Helmuth
for repair.
Return to Chadwick-Helmuth
for repair.
Return to Chadwick-Helmuth
for repair.
Return to Chadwick-Helmuth
for repair.
VXP System Maintenance Manual
Maintenance
4-3