Printer; Compactflash Card And Adapter; Compactflash Card Adapter Leading Particulars - Honeywell VXP System Maintenance Manual

Introduction

1.2.3 Printer

The printer for the VXP system is a portable thermal printer that connects directly to a dedicated
serial port on the Acquisition Unit via the 902-15371 AU to DU cable. This cable also brings
power to the printer from the accessory power supply in the AU. The printer contains an internal
Ni-MH battery that is charged while external power is being supplied. An AC adapter is also
provided for indoor use. The printer is configured using three internal DIP switches, which must
be set properly in order for the printer to work with the VXP system. Refer to section 2.2.3.2 for
information on checking and setting the DIP switches.
Parameter
Type
Operating Temperature: Printer/Disk Drive
Dimensions
Weight
Input Power
Power Source
Operating Temperature
Interfaces
Baud Rate

1.2.4 CompactFlash Card and Adapter

The VXP system includes a CompactFlash Card and Adapter that is used to transfer application
and configuration files to the system (upload) and data files from the system (download) for
storage. The adapter is for 8 or 16MB CompactFlash cards. The CompactFlash Adapter connects
to the VXP Display Unit through the PCMCIA interface. Table 1-6 contains the leading
particulars for the CompactFlash Card Adapter.
Table 1-6. CompactFlash Card Adapter Leading Particulars
Parameter
Dimensions
Input Power & Power Source
Operating Temperature
Storage Temperature
1-12 Honeywell
Table 1-5. Printer Leading Particulars
Characteristic
Dot-matrix thermal printer
-10° to +55° C
6.7 W x 2.6 H x 6.3 D (inches)
170 W x 66.5 H x 160 D (mm)
1.56 lbs. (0.7 Kg) including Ni-MH battery
12 Vdc @ 3.6 W nominal
VXP AU via 902-15371 cable or accessory
AC adapter (provided)
0° to +40° C
Serial, Parallel
9600 Baud
Characteristic
2.1 W x 0.2 H x 3.4 L (inches)
5.33 W x.51 H x 8.67 L (cm)
PCMCIA Port
+5° to +40° C
-30° to +60° C