Makita EM4350RH Instruction Manual page 12

For metal blades
CAUTION:
Make sure that the protector tightening bolts are tightened evenly so that
●
the gap between the clamp and the protector will be constant.
Otherwise, the protector sometimes may not function as specified.
(For Type A protector)
Fix the protector (3) to the clamp (2) with two bolts M6x30 (1).
(For Type B protector)
Fix the protector to the clamp (4) with two bolts M6x18 (5).
If the protector cover (6) is installed on the shaft, remove it first as follows.
1. Remove the washers (7), bolts M6x30 (8) from protector cover.
2. Remove the protector cover by slightly spreading the fin (9).
NOTE:
When changing the protector from Type B to Type A, install the protector
●
cover, bolts M6x30 and washers onto the shaft before installing the
protector.
For nylon cutting head
Be sure to mount the nylon cutting head protector (10) onto the type A metal
●
blade protector (3) assembled with the nylon cutting head protector.
Mount the nylon cutting head protector (10) by sliding it into place from the
●
flank of the metal blade protector (3).
Remove tape adhered to cutter, which cuts nylon cord, on nylon cutting head
●
protector (10).
CAUTION:
Be sure to push in nylon cutting head protector (10) until it is fully inserted.
●
Take care not to injure yourself on the cutter for cutting the nylon cord.
To remove the nylon cutting head protector (10), apply a hex wrench (11) into
●
the notch on the metal blade protector (3), push it in and meanwhile slide the
nylon cutting head protector (10).
(5)
(8)
(6)
(7)
12
(1)
(2)
(3)
(4)
(9)
(3)
(10)
(11)