Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 88

Installing the Displays
Attach the displays to the display structures by completing the following steps:
Step 2
a.
b.
Do not place your hand or fingers between the display and the display support arm when you lower the
Caution
displays onto the structure.
c.
d.
Figure 5-2 Mounting the Displays (1 of 2)
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
5-4
Chapter 5
Align the four spools on the back of the display to the mounting locations on the structure.
Place the spools through the openings in the structure.
The display then rests on the display support arm on the structure.
Confirm that the spools are still tightly screwed onto the displays. If they are not, tighten them
completely.
Ensure that there is approximately a 2mm (1/16 inch) gap between each display and, if required,
adjust the displays to achieve that distance.
Installing the Displays and Performing Final Leveling of the Main Display Structure
OL-27038-01