Assembling A 4-Seat Second Row For A 10-Seat Tx9200 System - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Assembling a 4-Seat Second Row For a 10-Seat TX9200 System

Assembling a 4-Seat Second Row For a 10-Seat TX9200 System
To assemble a second row table with three table legs and two table sections, complete the following
steps.
Unpack each table leg.
Step 1
Set the table legs upside-down and place them in approximately the position where they are during the
Step 2
final installation.
Check the label on top of the each leg to determine the placement.
Tip
With the leg still upside-down, measure the gap between the hex nut on the leveling foot and the
Step 3
structure.
If required, adjust the nut until the distance between the hex nut and the structure is 22mm.
Step 4
Figure 13-32 Adjusting the Leveling Feet on the Table Legs
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
13-40
Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
OL-27038-01