Table of Contents
Advertisement
Rear Transition Module for CPIP5430
5
5-8
7. With the CPIP5430-RTM1 in the correct vertical position that matches
the pin positioning of the backplane, and the levers of the two
injector/ejector handles in the outward position, carefully slide the
transition module into the appropriate slot and seat tightly into the
backplane.
8. Simultaneously move the injector/ejector levers in an inward direction
so they lock in place.
9. Secure in place with the screws provided on the outside edge of each
injector/ejector lever. Be sure the screws make good contact with the
transverse mounting rails to minimize RF emissions.
10. Connect the appropriate cables to the rear of the transition module.
11. Replace the chassis or system cover(s), reconnect the system to the AC
or DC power source, and turn the equipment power on, or if hot
swapping, you may now install the CPIP5430 SBC.
Computer Group Literature Center Web Site
Advertisement
Table of Contents
