Table of Contents
Advertisement
2. Insert a vendor-approved DIMM into one of the slots located on the
top side of the board.
3. Press firmly until the DIMM is seated into the slot. It should click into
place.
2.5-inch HDD Installation
One slim-line 2.5-inch HDD can be installed on the CPIP5430 controller
instead of a standard PMC, if not already installed from the factory.
The following procedure describes how to mount a 2.5 inch hard disk drive
on one of the PMC sites of the CPIP5430. If the CPIP5430 is currently
installed in a system chassis, perform the following steps.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. Keep the ESD secured throughout this
procedure.
2. Shut down the operating system.
3. Remove the chassis or system cover(s) as necessary.
http://www.motorola.com/computer/literature
4275 0404
2.5-inch HDD Installation
1-11
1
Advertisement
Table of Contents
