Table of Contents
Advertisement
5Rear Transition Module for
This chapter includes information for installing and configuring the
CPIP5430-RTM1 transition module, which is designed to work in
conjunction with the CPIP5430 series of CompactPCI controller boards.
The sections include the following:
Features
The CPIP5430-RTM1 provides additional I/O capabilities to the
CPIP5430 SBC. It is a 6U x 80mm form factor and is installed directly in
the MXP backplane in the rear transition board slot of the chassis and
interfaces with the CPIP5430 board through the J3 and J5 connectors. This
RTM does not support hot swap and it can be serviced if the front
CPIP5430 SBC is removed or powered off.
Rear panel connectors include:
An additional IDE channel and Serial ATA are available on J3 and J5 from
the CPIP5430. Connections for the IDE include CompactFlash socket or
IDE hard drive. Connection for the optional Serial ATA hard drive is also
provided. There is also support for IPMI VPD via the J15 header.
Features
Block Diagram
Functional Descriptions
Preparing the RTM
Installing the RTM
Pin Assignments
One RJ45 connector for 10/100 /1000 Base-Tx Ethernet
Two USB ports
One RJ45 connector for asynchronous serial port COM2
CPIP5430
5
5-1
Advertisement
Table of Contents
