Table of Contents
Advertisement
What you need to do...
Install hard disk drive (if
required)
Install PMC module (if required)
Install the CPIP5430 in the
chassis
Install transition module into
chassis (optional).
Unpacking Guidelines
Unpack the equipment from the shipping carton. Refer to the packing list
and verify that all items are present. Verify that the coin cell battery is in
its holder and inserted correctly. Save the packing material for storing and
reshipping of equipment.
Note
Caution
Avoid touching areas of integrated circuitry; static discharge can damage
!
circuits.
Caution
Motorola strongly recommends that you use an antistatic wrist strap and a
ESD
Use ESD
conductive foam pad when installing or upgrading a system. Electronic
components, such as disk drives, computer boards, and memory modules
can be extremely sensitive to electrostatic discharge (ESD). After
removing the component from its protective wrapper or from the system,
Wrist Strap
place the component flat on a grounded, static-free surface (and, in the case
of a board, component side up). Do not slide the component over any
surface.
http://www.motorola.com/computer/literature
Table 1-1. Startup Overview (continued)
If the shipping carton is damaged upon receipt, request that the
carrier's agent be present during the unpacking and inspection of
the equipment.
Unpacking Guidelines
Refer to...
2.5-inch HDD Installation on page 1-11
PCI Mezzanine Card Installation on page
1-13
Installing a Board on page 1-15
Installing the RTM on page 5-7
1
1-3
Advertisement
Table of Contents
