Network Modules; 10-G Network Module - Cisco Firepower 4100 Series Hardware Installation Manual

Network Modules

Network Modules

The Firepower 4100 contains two network module slots that provide optical or electrical network interfaces.
Network modules are optional, removable I/O modules that provide either additional ports or different interface
types (1/10/40 G). The Firepower network modules plug into the chassis on the front panel.
For More Information

10-G Network Module

The following figure shows the front panel of the 10-G network module (FPR4K-NM-8X10G). The
FPR4K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Note
The FPR4K-NM-8X10G is NEBS-compliant.
Note You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Figure 8: FPR4K-NM-8X10G
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
10
• See 10-G Network Module , on page 10
• See 40-G Network Module , on page 11
• See Hardware Bypass Network Modules, on page 12
and the port configurations for the hardware bypass network modules.
• See Remove and Replace the Network Module, on page 55
replacing network modules.
for a description of the 10-G network module.
for a description of the 40-G network module.
for the location and description of the LEDs,
for the procedure for removing and
Overview