Cisco Firepower 4100 Series Hardware Installation Manual page 54

Install the FIPS Opacity Shield
Figure 42: Attach the Cable Management Bracket to the Slide Rail Locking Bracket
1 Cable management bracket
3 8-32 x .375-in. countersink Phillips head
screws (2 per side)
Step 5 Connect the cables to the ports. See
procedure. Make sure that the cables have enough slack to route them through the cable mounting brackets (as shown
in step 6 below).
If you are installing the FIPS opacity shield after the initial product installation, the cables are connected. If
Note
the attached cables do not have enough slack to route them through the cable mounting brackets (as shown
below), you will have to turn the power off on the appliance, remove the cables, route the cables through the
cable mounting brackets, reattach the cables, and continue with step 7 below.
Step 6 Route the cables through the openings in the cable management brackets.
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
50
2
Connect Cables, Turn on Power, and Verify Connectivity, on page 53
Slide rail locking bracket
Mount and Connect
for the