Connect Cables, Turn On Power, And Verify Connectivity - Cisco Firepower 4100 Series Hardware Installation Manual

Mount and Connect
• Cisco Firepower Threat Defense for Firepower 4100 Quick Start Guide

Connect Cables, Turn on Power, and Verify Connectivity

Take note of the following warnings:
Warning Statement 1021—SELV Circuit
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage
(TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and
WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Warning Statement 1051—Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Warning
Statement 1053—Class 1M Laser Radiation
Class 1M laser radiation when open. Do not view directly with optical instruments.
Warning
Statement 1055—Class I and Class 1M Laser
Class I (CDRH) and Class 1M (IEC) laser products.
After rack mounting the chassis, follow these steps to connect cables, turn on power, and verify connectivity.
Step 1
Connect to the console port.
Using a serial console cable, connect a computer or terminal server to the RJ-45 serial console port (baud rate is 9600)
so that you can use the CLI for initial setup.
Step 2
Connect to the management interface.
Install the 1-Gigabit Ethernet SFP transceiver that was provided in the accessory kit in the Management port, and then
using an Ethernet cable, connect a management computer directly to the SFP.
Use appropriate ESD procedures when inserting the SFP transceiver. Avoid touching the contacts at the rear,
Note
and keep the contacts and ports free of dust and dirt. Store unused SPF transceivers in their ESD packaging.
Warning Do not force an SFP transceiver into a socket. This can jam the transceiver and can cause permanent damage
to the transceiver, the chassis, or both.
Connect Cables, Turn on Power, and Verify Connectivity
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
53