Setting Tx Power - Honeywell OneWireless XYR 6000 Professional Installation Manual

14 Setting TX Power

Warning! The XYR 6000 Transmitter must be Professionally Installed in accordance with the requirements specified in this
document. Only the specified power settings, antenna types and gains and cable lengths (attenuation) as outlined in this
document are valid for XYR 6000 Transmitter installations.
TX Power setting is accomplished with the Authentication Device when a special application (app) is installed. This app is
considered to be Honeywell sensitive material and is made available only to the qualified Professional Installer.
When this app is installed in the AD, the XYR 6000 TX power setting, normally a read-only parameter, becomes a read/write
parameter.
Using the virtual keyboard in the Device Local Configuration AD routine to manipulate the local user interface (LUI),
navigate to the TX_POWER display in the RADIO setup group. The XYR 6000 as shipped from the factory should show a
TX Power value consistent with those given in Table 13 and Table 14.
The TX Power adjustment feature is provided for Professional Installers to adjust the XYR 6000 TX power to match the
specific selection of antenna and cables at the installation site and keep the total TX power under the regulatory thresholds.
OneWireless XYR 6000 Transmitter Honeywell Proprietary Rev B 27 August 2008
Professional Installation Guide 50021956 Page 23 of 28