Test Run - Grizzly G0960 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools away from machine.
2.
Confirm that blade is tensioned correctly (see
Tensioning Blade on Page 36).
3. Confirm that blade is tracking correctly (see
Adjusting Blade Tracking on Page 38).
4. Connect machine to power supply.
Model G0960 (Mfd. Since 09/22)
5. Turn machine ON by pulling ON/OFF switch
out (see Figure 61). Verify motor operation,
then turn machine OFF by pressing ON/OFF
switch in.
ON/OFF Switch
Figure 61. Location of ON/OFF switch.
6.
Remove switch disabling key, as shown in
Figure 62.
Figure 62. Example of removing disabling key
from ON/OFF switch.
7. Try to start machine with ON/OFF switch.
Machine should not start.
— If machine does not start, switch disabling
feature is working correctly.
— If machine does start, immediately stop
machine. Switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with reg-
ular operations. Call Tech Support for
help.
-33-