Cisco Nexus 7000 Series Configuration Manual page 77

LISP Instance-ID Support
Step 7
Step 8
Step 9
Step 10
Command or Action
ip lisp etr map-server map-server-address
key key-type authentication-key
Example:
switch(config)# ip lisp etr map-server
10.0.2.2 key 0 PURPLE-key
ip lisp itr
Example:
switch(config)# ip lisp itr
ip lisp etr
Example:
switch(config)# ip lisp etr
ipv6 lisp itr map-resolver
map-resolver-address
Example:
switch(config)# ipv6 lisp itr
map-resolver 10.0.2.2
Configuring Simple LISP Parallel Model Virtualization
Purpose
The locator address of the map
Note
resolver may be an IPv4 or IPv6
address. In this example, because
each xTR has only IPv4 RLOC
connectivity, the map resolver is
reachable using its IPv4 locator
address.
Up to two map resolvers may be
Note
configured if multiple map
resolvers are available.
Configures a locator address for the LISP map
server and an authentication key for which this
switch, acting as an IPv4 LISP ETR, will use
to register with the LISP mapping system.
Note The map server must be configured
with EID prefixes and instance IDs
matching those configured on this
ETR and with an identical
authentication key.
The locator address of the map
Note
server may be an IPv4 or IPv6
address. In this example, because
each xTR has only IPv4 RLOC
connectivity, the map-server is
reachable using its IPv4 locator
addresses.
Enables LISP ITR functionality for the IPv4
address family.
Enables LISP ETR functionality for the IPv4
address family.
Configures a locator address for the LISP map
resolver to which this switch will send map
request messages for IPv6 EID-to-RLOC
mapping resolutions.
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
65