Information About Lisp Esm Multihop Mobility; Licensing Requirements For Lisp; Guidelines And Limitations For Lisp Esm Multihop Mobility; Default Settings For Lisp - Cisco Nexus 7000 Series Configuration Manual

Information About LISP ESM Multihop Mobility

Information About LISP ESM Multihop Mobility

Licensing Requirements for LISP

The following table shows the LISP licensing requirements:
Product
Cisco NX-OS

Guidelines and Limitations for LISP ESM Multihop Mobility

LISP ESM multihop mobility has the following guidelines and limitations:
• Locator/ID Separation Protocol (LISP) multihop mobility is supported only in Extended Subnet Mode
• ESM multihop mobility requires OTV First Hop Redundancy Protocol (FHRP) isolation to avoid
• ESM multihop mobility does not support Network Address Translated (NAT'd) endpoint identifiers
• To properly route traffic between extended VLANs when the source and destination hosts are detected

Default Settings for LISP

This table lists the default settings for LISP parameters.
Table 4: LISP Default Settings
Parameters
feature lisp command
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
20
License Requirement
This feature requires the LAN_ENTERPRISE_SERVICES_PKG license. For a complete
explanation of the Cisco NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide.
(ESM) and it is recommended in combination with Overlay Transport Virtualization (OTV).
hair-pinning of traffic across the OTV Data Center Interconnect (DCI) framework.
(EIDs).
by FHRs at different data centers, we recommend one of the following designs:
• Establish a routing protocol adjacency between the first-hop routers (FHRs) in the different data
centers over a dedicated extended VLAN; redistribute host routes from LISP into the routing protocol
for discovered hosts at each data center FHR.
• Separate each mobile VLAN in a VRF and configure the LISP FHR within the related virtual routing
and forwarding (VRF) context. Set up an external site gateway xTR to act as router for all of the
mobile VLANs (VRFs).
Configuring LISP ESM Multihop Mobility
Default
Disabled