Cisco Nexus 7000 Series Configuration Manual page 72

Configuring a Remote Site for Large-Scale LISP Shared Model Virtualization
Step 6
Step 7
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
60
Command or Action
ip lisp itr map-resolver map-resolver-address
Example:
Switch(config-vrf)# ip lisp itr
map-resolver 172.16.1.2
Repeat Step 6 to configure another locator
address for the LISP map resolver
Example:
Switch(config-vrf)# ip lisp itr
map-resolver 172.16.1.6
LISP Instance-ID Support
Purpose
pointing to itself for registration (and its
neighbor xTR/MS/MR at the same site).
Configures a locator address for the LISP map
resolver to which this switch will send map
request messages for IPv4 EID-to-RLOC
mapping resolutions.
• In this example, the map resolver is
specified within switch lisp configuration
mode and inherited into all eid-table
instances since nothing is related to any
single instance ID. In addition, redundant
map resolvers are configured. (Because
the MR is co-located with the xTRs in
this case, this command indicates that this
xTR is pointing to itself for mapping
resolution (and its neighbor xTR/MS/MR
at the same site).
• The locator address of the map resolver
may be an IPv4 or IPv6 address. In this
example, because each xTR has only IPv4
RLOC connectivity, the map resolver is
reachable using its IPv4 locator address.
Up to two map resolvers may be
Note
configured if multiple map
resolvers are available.
Configures a locator address for the LISP map
resolver to which this switch will send map
request messages for IPv4 EID-to-RLOC
mapping resolutions.
Note In this example, a redundant map
resolver is configured. (Because the
MR is co-located with the xTRs in
this case, this command indicates
that this xTR is pointing to itself for
mapping resolution (and its
neighbor xTR/MS/MR at the same
site).
The locator address of the map
resolver may be an IPv4 or IPv6
address. In this example, because
each xTR has only IPv4 RLOC
connectivity, the map resolver is
reachable using its IPv4 locator
address.