Licensing Requirements For Lisp; Lisp Guidelines And Limitations; Default Settings For Lisp - Cisco Nexus 7000 Series Configuration Manual

Licensing Requirements for LISP

to LISP sites. This process not only facilitates LISP/non-LISP internetworking but also allows LISP sites to
see LISP ingress traffic engineering benefits from non-LISP traffic.
Proxy ETR (PETR)—This device is a LISP infrastructure device that allows IPv6 LISP sites without native
IPv6 RLOC connectivity to reach LISP sites that only have IPv6 RLOC connectivity. In addition, the PETR
can also be used to allow LISP sites with Unicast Reverse Path Forwarding (URPF) restrictions to reach
non-LISP sites.
Licensing Requirements for LISP
The following table shows the LISP licensing requirements:
Product
Cisco NX-OS

LISP Guidelines and Limitations

LISP has the following configuration guidelines and limitations:
• LISP requires the Cisco Nexus 7000 Series 32-Port, 10 Gigabit Ethernet (M1) module (N7K-M132XP-12
• Use an Overlay Transport Virtualization (OTV) or another LAN extension mechanism to filter the HSRP
• Make sure that the HSRP group and the HSRP Virtual IP address in all data centers in the extended LAN
• LISP VM mobility across subnets requires that the same MAC address is configured across all HSRP
• LISP is not supported for F2 Series modules.
• From Release 8.2(1), LISP is supported on F3 and M3 line cards.

Default Settings for LISP

This table lists the default settings for LISP parameters.
Table 2: LISP Default Settings
Parameters
feature lisp command
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
6
License Requirement
This feature requires the LAN_ENTERPRISE_SERVICES_PKG license. For a complete
explanation of the Cisco NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide.
or N7K-M132XP-12L), with Electronic Programmable Logic Device (EPLD) version 186.008 or later.
hello messages across the data centers to create an active-active HSRP setup and provide egress path
optimization for the data center hosts.
are the same. Keeping the HSRP group number consistent across locations guarantees that the same
MAC address is always used for the virtual first-hop gateway.
groups that allow dynamic EIDs to roam. You must enable the Proxy Address Resolution Protocol (ARP)
for the interfaces that have VM mobility enabled across subnets.
Configuring Locator ID Separation Protocol
Default
Disabled