Configuring Database Application For Redistribution Of Rib Routes Into Lisp - Cisco Nexus 7000 Series Configuration Manual

Configuring Database Application for Redistribution of RIB Routes into LISP

The redistribution of RIB routes into LISP is enabled under the VRF Context and supports both IPV4 and
IPV6 address families.
The following RIB sources are supported for LISP redistribution:
Table 11: Supported RIB Sources for Route Import
Source
bgp
direct
eigrp
isis
ospf
ospfv3
rip
static
Configuring Database Application for Redistribution of RIB
Routes into LISP
Locator ID Separation Protocol (LISP) egress tunnel routers (ETR) import prefixes with a local RIB route
into the LISP EID database and register it with the Mapping System. Perform the following steps on a xTR
device in a LISP topology.
Before you begin
• Enable the LISP feature.
Procedure
Step 1
Step 2
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
116
Command or Action
configure terminal
Example:
switch# configure terminal
vrf context vrf-name
Example:
switch(config)# vrf context VRF1
Redistribution of RIB Routes into LISP
Description
Border Gateway Protocol (BGP)
Connected
Enhanced Interior Gateway Routing Protocol (EIGRP)
ISO IS-IS
Open Shortest Path First (OSPF)
OSPFv3
Routing Information Protocol (RIP)
Static routes
Purpose
Enters global configuration mode.
Creates a new VRF and enters VRF
configuration mode.
The value of the vrf-name is any case-sensitive,
alphanumeric string of up to 32 characters.