Playback; Tape Playback; Volume Control - Sharp Viewcam VL-WD450U Operation Manual

Tape Playback
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.
Media Selection switch
Power switch
Operation button
1 Open the LCD monitor and adjust the
angle (see page 19).
2
Set the Media Selection m)
switch to TAPE.
3 Hold down the Lock button
and set the Power switch to
VCR.
4
Lock bu_on
Press _ (or _,_) on the Operation
button to rewind (or fast forward) the
tape to the desired point.
AUDIO1 +2
5
Press _- / nl to begin playback.
AUDI01+2
To stop playback
Press I.
To turn the power off
Set the Power switch to OFF without pressing
the Lock button.
Notes:
• The tape is automatically rewound when
playback reaches the end of the tape.
• Stereo earphones with a 3.5 mm diameter plug
can be plugged directly into the PHONES jack.
When you use this jack, the speaker automati-
cally turns off.
Watching the Playback in the
Viewfinder
You can also watch the playback in the
viewfinder by closing the LCD monitor with the
screen facing in. You cannot monitor the sound
through the speaker when watching the
playback in the viewfinder.
Volume Control
When the camcorder is in TAPE-VCR mode,
push the Volume control to the + or - side to
increase (_) or decrease (_2_)the volume.
The volume level indicator will appear on the
LCD screen during adjustment only. Once the
Volume control is released, the volume level
indicator will disappear shortly afterwards.
23