Still Recording On Tape - Sharp Viewcam VL-WD450U Operation Manual

Useful Features
Camera Recording
_i!iiii_!iiii!iiiii_!ii!;iii!!iil_i
iii!i!iiiiiiiiiiiii;!i_i!ii!ii!i!i!;i!i!i!i
Still Recording on Tape
You can record still images of subjects with
normal sound on a tape by selecting one of two
still recording modes.
Type of Still Recording modes
SNAP: A still picture is recorded for 6 seconds.
STILL: A continuous still image is recorded.
Selecting Still Recording Mode
1
Set the camcorder to TAPE-CAMERA
mode.
2
3
Press the MENU/DISPLAY button until
the menu screen appears.
Select I_, then press _,_ on the
Operation button. Select"SNAP EFE"
(_), then press _ (_).
4
Press • or _-/11 to select"OFF", then
press <,I.
5 Press _-/H (_) to select"PHOTO
SNAP", then press _,_ (_).
6
Press • or _-/ll to select the desired
still recording mode, then press <,I.
Press the MENU/DISPLAY button to
turn off the menu screen.
Using Still Recording
1
Set the camcorder to TAPE-CAMERA
mode.
2
In Recording Standby
mode, press the STILL
button.
• A still image of the subject
is displayed.
3
Press the REC START/STOP
button.
• The still image of the subject
will be recorded.
In SNAP mode, the camcorder returns to
Recording Standby mode after recording
a still image for 6 seconds.
To pause recording
Pressthe REC START/STOPbutton.
To cancel the still image
In SNAP mode, press the STILL button while
the camcorder is in Recording Standby
mode.
In STILL mode, press the STILL button.
Notes:
• Still Recording can also be used during
recording by pressing the STILL button.
• The picture quality in Still Recording mode will
be slightly lower than normal pictures.
39